LUCENT TECHNOLOGIES

RTNI-ATI/ASI

Card Type   Telephony
Chip Set    Unidenified
I/O Options MVIP bus
Data Bus    16-bit ISA

[Image]

                                CONNECTIONS

         Function            Label            Function            Label

  MVIP bus                    J1       Telephone lines out          J4

  48V DC power                J2       Line modules               J10-J33

  48V DC power                J3

                                          BASE I/O ADDRESS

  Setting    E1/A     E1/B     E1/C     E1/D    E1/E     E1/F     E1/G     E1/H     E1/I     E1/J

      000h  Closed   Closed   Closed   Closed   Closed   Closed   Closed   Closed  Closed   Closed

      001h  Closed   Closed   Closed   Closed   Closed   Closed   Closed   Closed  Closed    Open

      002h  Closed   Closed   Closed   Closed   Closed   Closed   Closed   Closed   Open    Closed

      003h  Closed   Closed   Closed   Closed   Closed   Closed   Closed   Closed   Open     Open

      004h  Closed   Closed   Closed   Closed   Closed   Closed   Closed   Open    Closed   Closed

  »   308h   Open     Open    Closed   Closed   Closed   Closed   Open     Closed  Closed   Closed

      3FBh   Open     Open     Open     Open    Open     Open     Open     Closed   Open     Open

      3FCh   Open     Open     Open     Open    Open     Open     Open     Open    Closed   Closed

      3FDh   Open     Open     Open     Open    Open     Open     Open     Open    Closed    Open

      3FEh   Open     Open     Open     Open    Open     Open     Open     Open     Open    Closed

      3FFh   Open     Open     Open     Open    Open     Open     Open     Open     Open     Open

            Note: A total of 2047 base address settings are available. The jumpers are a binary
            representation of the decimal memory addresses. E1/A is the Most Significant Bit and
            jumper E1/J is the Least Significant Bit. The jumpers have the following decimal
            values: E1/A=512, E1/B=256, E1/C=128, E1/D=64, E1/E=32, E1/F=16, E1/G=8, E1/H=4,
            E1/I=2, E1/J=1. Open the jumpers and add the values of the open jumpers to obtain the
            correct memory address. (Open=1, Closed=0)

                           MVIP BUS TERMINATION

            Setting                      W1                   W2

  »          Terminated                Closed               Closed

           Not terminated               Open                 Open